If your Samsung dishwasher is not cleaning your dishes properly, you should know some of the problems you can fix. For example, you may have a malfunctioning control panel or a dirty filter. You can also try cleaning the filter to fix the problem. To troubleshoot your machine, follow these steps:
Problems with a Samsung dishwasher
When you notice that your Samsung dishwasher is not working properly, there are a few things that you can try. These include changing the connections on the motor and the circuit boards. However, if these steps do not solve your problem, you should consult an authorized Samsung service centre. A faulty relay switch or thermostat could also be to blame.
Another potential cause of a Samsung dishwasher not functioning is a power cut. When this happens, your dishwasher might not start or display error codes. The easiest way to solve this problem is to remove all the dishes from the dishwasher and reset the machine. This should fix the issue permanently. If this fails, call a professional to repair your Samsung dishwasher.
Contact a Samsung service technician when your dishwasher stops working after the LE code. You could spend more money if the tech does not diagnose the problem properly. Ultimately, it may be necessary to buy a new Samsung dishwasher. You can use this service to avoid paying out of pocket for the repairs if you have a warranty.
The touchpad is an integral part of your Samsung dishwasher. It controls many of its functions, including the time remaining in each cycle. If it is not working correctly, the touchpad may be the culprit.
Fixing a faulty control panel
A faulty control panel on a Samsung dishwasher can cause various problems. A malfunctioning panel will display error codes and flashing lights to indicate something is wrong. Some error codes indicate problems with the drain hose or the water heater. These issues can be fixed by rebooting the control panel or contacting a Samsung technician for assistance.
A faulty control panel can also cause a Samsung dishwasher not to turn off properly. The first step is to remove all the dishes from the machine and hold the Start/Reset button for a few seconds. Next, turn off the power to the dishwasher for about 60 seconds. This should resolve the issue for good. Of course, you can always contact a service centre for assistance if the problem persists.
A high-temperature error means that the water temperature setting is too high. In such a case, the water temperature setting should be below 175F. If it is higher than this, contact a Samsung technician for assistance. If the error persists, the water inlet valve is likely a problem.
Another reason why a Samsung dishwasher won’t start is a faulty power control board. This board is accessible through the lower access panels. To replace the control board, you will need to dismantle the appliance. Afterwards, you must replace the switch door latch and locking mechanism.
Cleaning a clogged filter
If your Samsung dishwasher is not pumping wastewater into the drain pipe, there is a good chance that the wastewater pump is clogged. In this case, the appliance will not be able to clean the dishes. To clear the clog, run water into the kitchen sink. If this does not work, call a Samsung technician for service. This technician should be able to diagnose the problem.
The filter assembly of a Samsung dishwasher has three parts: the coarse, fine, and primary filters. Each filter has a different function and size. For example, the coarse filter traps larger particles, while the fine filter traps smaller ones. Therefore, cleaning the filter assembly regularly is important to prevent damage to the dishwasher.
Another part of the filter is the water inlet assembly. This assembly plays a major role in draining the dishwasher. If this part is clogged, it should be easy to remove it and replace it. Unfortunately, the water inlet assembly is often made of small pieces of food sucked into the drain.
Unplug the power cord from your Samsung dishwasher to clean a clogged filter. Remove the filter door, and then wipe the filter door with a damp cloth. Next, soak the filter in vinegar overnight. After soaking, rinse the filter door thoroughly. Repeat steps two and three and places the door and filter back into place.
